NEC uPD78056Y - Manual (Page 156)

156
CHAPTER 6 PORT FUNCTIONS
6.4 Port Function Operations
Port operations differ depending on whether the input or output mode is set, as shown below.
6.4.1 Writing to input/output port
(1) Output mode
A value is written to the output latch by a transfer instruction, and the output latch contents are output from
the pin.
Once data is written to the output latch, it is retained until data is written to the output latch again.
(2) Input mode
A value is written to the output latch by a transfer instruction, but since the output buffer is OFF, the pin status
does not change.
Once data is written to the output latch, it is retained until data is written to the output latch again.
Caution In the case of 1-bit memory manipulation instruction, although a single bit is manipulated
the port is accessed as an 8-bit unit. Therefore, on a port with a mixture of input and output
pins, the output latch contents for pins specified as input are undefined except for the
manipulated bit.
6.4.2 Reading from input/output port
(1) Output mode
The output latch contents are read by a transfer instruction. The output latch contents do not change.
(2) Input mode
The pin status is read by a transfer instruction. The output latch contents do not change.