NEC uPD78056Y - Manual (Page 436)

436
CHAPTER 18 SERIAL INTERFACE CHANNEL 1
(a) When the automatic transmit/receive function is used by the internal clock
If bit 1 (CSIM11) of serial operation mode register 1 (CSIM1) is set at (1), the internal clock operates.
If the auto send and receive function is operated by the internal clock, interval timing by CPU processing
is as follows.
When bit 7 (ADTI7) of automatic data transmit/receive interval specify register (ADTI) is set to 0, the
interval depends on the CPU processing. When ADTI7 is set to 1, it depends on the contents of the ADTI
or CPU processing, whichever is greater.
Refer to Figure 18-5, “Automatic Data Transmit/Receive Interval Specify Register Format” for the intervals
which are set by the ADTI.
Table 18-2. Interval Timing Through CPU Processing (when the internal clock is operating)
CPU Processing Interval Time
When using multiplication instruction Max. (2.5T
SCK
, 13T
CPU
)
When using division instruction Max. (2.5T
SCK
, 20T
CPU
)
External access 1 wait mode Max. (2.5T
SCK
, 9T
CPU
)
Other than above Max. (2.5T SCK , 7T CPU )
Remark T SCK : 1/f SCK
f
SCK
: Serial clock frequency
T CPU : 1/f CPU
f CPU : CPU clock (set by bits 0 to 2 (PCC0 to PCC2) of the processor clock control
register (PCC) and bit 0 (MCS) of the oscillation mode selection register (OSMS))
MAX. (a, b) : a or b, whichever is greater
Figure 18-24. Operation Timing with Automatic Data Transmit/Receive Function Performed by
Internal Clock
f X : Main system clock oscillation frequency
f CPU : CPU clock (set by bits 0 to 2 (PCC0 to PCC2) of the processor clock control register (PCC) and
bit 0 (MCS) of the oscillation mode select register (OSMS).
T CPU : 1/f CPU
T SCK : 1/f SCK
f SCK : Serial clock frequency
f
X
f
CPU
SCK1
SO1
SI1
T
CPU
T
SCK
D7 D6 D5 D4 D3 D2 D1 D0
D7 D6 D5 D4 D3 D2 D1 D0
Interval