Accusys ExaRAID GUI - Manual (Page 106)

Using the RAID GUI
2-66
Add Event Receivers
You can add a maximum of three mail recipients. Click Add to set the
receiver ID, mail receiver address, and the corresponding severity level.
Remove Event Receivers
Select the mail recipient(s) you want to delete and click Remove. The
selected mail recipients are deleted.
Modify Event Receivers
Select a mail recipient you want to change for its mail address and the
event severity level. Click Modify to enter the settings screen.
2.9.2 Setting up the SNMP
SNMP (Simple Network Management Protocol) is a widely used protocol
based on TCP/IP for monitoring the health of network-attached
equipments. The RAID controller is equipped with an embedded SNMP
Agent to support SNMP-based monitoring. You can use SNMP
applications (SNMP v1 or v2c-compliant) at remote computers to get
event notification by SNMP traps and watch the status of a RAID system.
Please contact your RAID system provider to get the MIB (Management
Information Base) file and import the MIB file to your SNMP manager
before enabling this feature.
Mail Retry Period (minute): 10 (default)
Specify the period of time in minutes to retry sending event
notification mail. The range is from 10 to 60.
Mail Delay Time (second): 10 (default)
Specify the delay time in seconds to send out multiple events in one
mail. This helps to reduce the number of mails. The range is from 5 to
60.
Notify State: On / Off (default)
This option enables or disables the SNMP trap event notifications.
SNMP Agent State: On / Off (default)
This option enables or disables the SNMP Agent for status watching.
Port :161 (default)
Set up the port by which the SNMP Agent receives the status retrieval
commands from SNMP applications.
Community Name: public(default)