Accusys ExaRAID GUI - Manual (Page 116)

Using the RAID GUI
2-76
• If you select the NTP mode, specify the IP address or the domain
name of the NTP server. The NTP server automatically synchronizes
the controller clock at 23:59 every day.
3. Click Apply, and the settings are effective immediately.
• Setting up the Time-Zone
1. Select System Management > Time from the main menu.
2. From the Time-Zone Mode drop-down menu, select location of country.
3. From the DST(Daylight saving time) Status Mode drop-down menu,
select On/Off(default).
4. Click Apply, and the settings are effective immediately.
2.10.5 Security control
The settings in the Security page allows you to change the password and
login related settings.
• User setting
To change the password of a specified user, do the following:
1. Specify either Administrator or User from the Specified User drop-down
menu.
2. Check the “Change Password” checkbox, and a pull-down menu
appears. Fill in the passwords in each field.
3. If you want to enable or disable password checking before login,
specify the options from the Password Check drop-down menu.
• Global Setting
To enable or disable the auto logout function, select either On or Off from
the Auto Logout drop-down menu. By default, the auto logout time is 10
minutes.
Set the Password Reminding Mail option to On to enable the controller to
send out a password reminding email when users forget their password.
An email account is also required.
• SSL Setting
A secure connection is always required to login to the GUI; therefore, ‘SSL
Forced’ is enabled by default and users are forced to connect to the
system via HTTPS.
Note
If the NTP server is located outside your LAN, make sure the gateway
and domain name server is configured properly for the RAID
controller to conect to the NTP server.