Accusys ExaRAID GUI - Manual (Page 164)

Using the CLI Commands
4-33
4.9 System Management
4.9.1 Configurations management
Command autoshutdown
Synopsis autoshutdown [on/off] [-e upsac/fan/temp] [-t xxmin]
Description Review or set the auto shutdown function.
Parameters
[on/off]: enable or disable the auto shoutdown function
[-e upsac/fan/temp]: event to trigger auto shutdown. (UPS
AC power loss and then low battery or UPS connection loss,
all fan failure, or over temperature)
[-t xxmin]: shutdown delay time
Command configrestore
Synopsis configrestore [-h]
Description
Erase all configurations on NVRAM or hard disks and restore
to factory default.
Parameters [-h]: erase configurations on all hard disks instead of NVRAM
Command configerase
Synopsis configerase hddx hddy …
Description Erase controller’s configurations stored on hard disks.
Parameters
[-f]: force to erase. If this option is specified, the
configurations on the hard disk will be unconditionally
erased.
Command configtohdd
Synopsis configtohdd hddx
Description Save NVRAM configurations to a hard disk.
Command configfromhdd
Synopsis configfromhdd hddx
Description Restore NVRAM configurations from hard disks.
Command configget
Synopsis configget config.bin
Description
Get main configurations stored on NVRAM and save to a file,
config.bin.