Accusys ExaRAID GUI - Manual (Page 112)

Using the RAID GUI
2-72
To make the settings effective, click Apply.
2.10 System Management
2.10.1 Restoring to factory settings
To clear the NVRAM or hard disk configurations, do the following:
1. Select the “Erase configurations on NVRAM” or the “Erase
configurations on HDD(s)” option to clear all configurations made on
NVRAM or hard disks.
2. When the “Erase configurations on HDD(s)” option is selected, specify
the hard disks or a hard disk to clear the configurations on it.
3. Click the Apply button, and the erase configuration message appears.
Click Confirm to restore factory default values.
2.10.2 NVRAM configuration
The controller’s configurations are stored in either NVRAM or hard disk(s)
depending on configuration types. The following options allows you to
manage the configuration data.
Save the NVRAM configuration to HDD(s)
Specify this option to save the NVRAM configuration data to a hard disk
or all hard disks.
When a path failover occurs, the controller will send out warning
events to notify users after the specified delay time (in minutes). The
range is between 0 and 60.
Note
1. The “Erase configurations on HDD(s)” option will be available
only when hard disks are in foreign, conflict, or unknown state.
2. After the erase command is applied to NVRAM, the controller will
restart immediately.
Figure 2-26 Options in the Configurations screen-1
(System Management menu)