Accusys ExaRAID GUI - Manual (Page 152)

Using the CLI Commands
4-21
4.5.4 FC ports
Command scprate
Synopsis
scprate scpx/all async/fast/fastwide/ultra/ultrawide/ultra2/
ultra2wide/ultra3/ultra320
Description
You can sets the preferred data rate of a SCSI port (scpx) or
all SCSI ports (all), as Asynchrous SCSI (async), Fast SCSI (fast),
Fast-Wide SCSI (fastwide), Ultra SCSI(ultra), Ultra Wide SCSI
(ultrawide), Ultra2 SCSI (ultra2), Ultra2 Wide SCSI(ultra2wide),
Ultra3 SCSI (ultra3), or Ultra-320 SCSI (ultra320),The
default is ultra320.
Command scpdefid
Synopsis scpdefid scpx scsi_id
Description
you can sets the default SCSI ID of a SCSI port (scpx) to
scsi_id which valid value are 0~15. The default SCSI ID is 0.
Command scplistusrconf
Synopsis scplistusrconf scpx/all
Description
Displays the user configurations of a SCSI port (scpx) or all
SCSI ports (all).
Command scplistcurconf
Synopsis scplistcurconf scpx/all
Description
Displays the current configurations of a SCSI port (scpx) or all
SCSI ports (all).
Command fcpname
Synopsis fcpname fcpx name
Description Name an FC port.
Command fcploopid
Synopsis fcploopid fcpx id/auto
Description Set the hard loop ID of an FC port.
Parameters
id: hard loop ID
auto: automatically determined
Command fcpconmode
Synopsis fcpconmode fcpx/all al/fabric/auto
Description Set the connection mode of an FC port or all FC ports.
Parameters
al/fabric/auto: arbitration loop, fabric, or automatically
determined