Accusys ExaRAID GUI - Manual (Page 124)

Using the LCD Consolel
3-1
Chapter 3: Using the LCD Console
3.1 Starting LCD Manipulation
The RAID system has a front LCD panel which supports a quick
configuration and RAID monitoring. You can use the four buttons on the
LCD panel to manipulate the LCD configuration utility. Each state and
display sequence is illustrated as below:
Once the RAID system is powered on, the booting information starts to
display on the LCD panel. If the system is ready, status messages are
displayed sequentially. If not, error messages are displayed and the
system is halted. See the details of status and emergent messages in the
following section 3.2 LCD Messages.
3.1.1 Confirm password
To enter the menu, a password may be required depending on your
settings. The default password is “0000”. Use the buttons for password
input. See the use of buttons as below.
UP/DOWN: Select the numbers 0 to 9, characters “a” to “z”.
ENT: Enter the selected character, or confirm the password if no
character is selected.
ESC: Backspace, or go back to the status info if password is empty.
1. Boot up info
Press ENT
(Clear)
Press ENT
system fail system ready
emergent events Press ESC
Press ESC
Password
passed
3. Error info
2. Emergent info 7. Confirm password
6. Menu
5. Configuration
4. Status info
Empty
Press ENT
(Clear)
Press UP/DOWN to select items
Press ESC/ENT to enter/exit sub-menu
Press ESC
(password error)
Press ESC
Press ESC or
1 minute time out
Figure 3-1 LCD manipulation procedure