Accusys ExaRAID GUI - Manual (Page 163)

Using the CLI Commands
4-32
4.8.3 Event handling
Command eventmailconfig
Synopsis eventmailconfig [-j subject] [-r xmin] [-d xsec] [-c content]
Description Display or set the event mail configurations.
Parameters
[-j subject]: event mail subject
[-r xmin]: event mail retry period
[-d xsec]: event mail delay time
[-c content]: event mail content
Command snmptraprcv
Synopsis
snmptraprcv set rcvx server port version community severity
snmptraprcv reset rcvx
Description
Enable or disable the specified SNMP server for SNMP trap
notification receiver.
Parameters
set/reset: set or clear receiver
rcvx: receiver identifier
server: SNMP server address
port: SNMP server port number
version: SNMP protocol version
community: SNMP community name
severity: severity level to notify
Command snmptraptest
Synopsis snmptraptest rcvx
Description Send a test SNMP trap to the specified server.
Command snmpagent
Synopsis snmpagent on [-p port] [-c community]
Description
Enable or disable the SNMP agent which allow SNMP
browser to obtain information from the controller.
Parameters
[-p port]: SNMP agent port number
[-c community]: SNMP community name
Command autowritethrough
Synopsis autowritethrough [on/off ctl/bbm/pow/fan/ups]
Description Review or set the auto write-through function.
Parameters
ctl/bbm/pow/fan/ups: controller failure, battery backup
module failure, power supply unit failure, fan failure, or UPS
failure