EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 127)

Modifying the Audio Routing or Type
Introduction
Audio routing settings can be modified in the Advanced Audio Settings pages (p.3-6) of
the Channels tab:
• Changing the audio type for all audio channels of a page at the same time is possible
using the shortcut keys described below. Changes on individual channels are also
possible by manually editing the audio type value.
• Changing the routing of an individual audio channel can be done by editing the cell
value in the advanced audio settings tables.
Collective Editing Actions
You can apply the following editing actions to all audio channels of a page using the
following shortcuts, when available on the current page:
Command description Command key
Set all audio channels to Embedded CTRL+E
Set all audio channels to Digital CTRL+D
Set all audio channels to Analog CTRL+A
Set all audio channels to Embedded Dolby E or Digital
DolbyE CTRL+Y
Set all audio channels to None CTRL+N
Reset all the audio configuration (also on other pages) to
default values F5
Route all audio input channels of REC1 to the other record
channels (only audio inputs) CTRL+0
Validating the changes ALT+A
Individual Editing Actions
To modify individual field/cell values (audio type or audio routing), use the general editing
commands that are described again below:
Command description Command key
Selecting a field value TAB
Scrolling down in the list of the possible values for the
selected field SPACEBAR
Scrolling up in the list of the possible values for the selected
field SHIFT + SPACEBAR
117 3. Multicam Configuration
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B