EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 188)

Record trains OUTs
Description Specifies whether Multicam will freeze or play through when it
reaches an OUT point marked on the record train that is being
played back.
Values Two values are possible for this parameter:
• Play through:
Multicam will still countdown to the OUT point, but will
keep playing through this point.
• Freeze:
Multicam will countdown to the OUT point and will
automatically freeze:
◦ on that picture if the Post-Roll mode is disabled
◦ on that picture + the Post-Roll duration if the Post-Roll
mode is enabled.
When playing a clip, Multicam always freezes on the OUT
point (or OUT point + Post-Roll duration when Post-Roll mode
is enabled).
Default value Play through
Default copy/move
Description Specifies whether the copy operations should be executed
preferably using the SDTI or the Gigabit network.
Values Two values are possible for this parameter:
• SDTI:
The copy operations are first executed through the SDTI
network. If the SDTI network is temporarily unavailable,
the transfer is then tried through the Gigabit interface.
Transfers to GigE targets will always be performed via the
GigE interface.
• Gigabit:
The copy operations are first executed via the GigE
interface.
If the transfer is not possible (ports not connected, IP
address unknown, no more connection ports are available),
the transfer is then tried through SDTI.
The value is forced to Gigabit if the code 117 (SDTI) is not
valid on the EVS server, or if the SDTI network is not active.
Default value SDTI
XT2 Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 178