EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 34)

The password protection has the following impact on the various user interfaces:
• The password is required to apply changes to configuration parameters in the server-
based application and in the web-based interface.
• On the Remote Panel, the Technical Setup menu is not available.
How to Activate the Password on the EVS Server
To activate a password on the EVS server, proceed as follows:
1. In the Multicam Setup window, press W to call the Enable password command. A
warning message opens.
2. Read the warning message carefully. Press the RIGHT ARROW key to select 'Yes'
and press ENTER to activate the password protection.
The password protection is directly active in all user interfaces, for all configuration
parameters on all configuration lines.
Enabling Changes to Configuration Parameters
In the Server-Based Application
When the password protection is active, the following message is displayed in red at the
top of each configuration tab in the Multicam Configuration window:
To enable changes in the configuration parameters during the session, you will be
prompted for the password the first time you save changes to configuration parameters in
a session.
In the Web-Based Interface
When the password protection is active, the Multicam Configuration window is
completely dimmed and a closed lock icon is displayed at the top of the window:
To enable changes in configuration parameters during the browser session, proceed as
follows:
1. Click the Lock icon .
2. Enter the password on the dialog box that is displayed.
3. Press OK.
The close lock icon changes to an open lock icon , and the parameters can be
modified and saved for the browser session.
XT2 Server - Version 11.01 - Configuration Manual
2. Multicam Setup 24