EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 132)

The following screenshot shows the Timecode Insertion settings in SD on page 9 of the
Channels tab in the server-based application:
The screenshot below shows the Timecode Insertion settings in HD.
In Loop
D-VITC
The D-VITC (Digital Vertical Interval Timecode) and userbits are always written on the
monitoring SD outputs of the record codec and are the same as on the source video.
Lines
Description Lines on which the VITC must be written on the output
connectors of the record codec.
Values From 06-08 to 20-22
Default Values 14-16 in NTSC
19-21 in PAL
HD OUT (in HD)
HAnc LTC / HAnc VITC
Description Enables/disables the insertion of the embedded timecode
(HAnc LTC or HAnc VITC) in the HD output.
Values The values specified for the HAnc LTC and HAnc VITC fields
have to be the same. The values can be as follows:
• No No new timecode inserted in the output.
• In (default)
Same timecode as in the input inserted in
the output.
• LTC
Timecode from the LTC table inserted in the
output.
• USER
User-defined timecode inserted in the
output.
• TC 0
All HAnc LTC/HAnc VITC timecodes
generated in the video signal coming out of
the given PGM will remain static and fixed to
00:00:00:00.
XT2 Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 122