EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 26)

3. If requested, change the selection of configuration lines selected for export on the left
pane:
◦ By default, a cross is displayed in front of all configuration lines, which means
they are all selected for export.
◦ To deselect a line, use the UP ARROW or DOWN ARROW key to highlight the
requested line, and press SPACEBAR. The cross is removed, and the
deselected lines turn light gray.
4. Press TAB to shift the focus to the right pane.
5. If requested, change the location where the export folder will be created:
◦ By default, the export folder is created on the USB key root or on the local drive
folder the local drive folder C:/LSMCE/DATA/SETUP/USER.
◦ To change the folder where the export folder will be created, highlight the
requested folder. The last highlighted folder will be considered as the requested
location.
6. To start the export process, press ENTER.
7. When the selected lines are exported (as a .lin file), a message opens to confirm the
export. Click OKto acknowledge the message.
In the Web-Based Interface
Note
In the web-based interface, it is only possible to export configuration lines one by
one.
To export configuration lines from an EVS server in the web-based interface, proceed as
follows:
1. From the Multicam Setup window, click Export configuration lines in the Tools
menu.
The Export configuration lines window opens:
XT2 Server - Version 11.01 - Configuration Manual
2. Multicam Setup 16