EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 128)

Modifying the Audio Gain and Mute Settings
Introduction
From the Advanced Audio Settings pages (3-6) of the Channels tab, you can not only
modify the default routing of audio channels, but you can also do the following:
• adjust the audio gain for each audio mono channel individually
• mute individual audio channels.
The audio gain and audio mute information is hidden by default. The CTRL+G command
allows you to toggle the display in the tables to show the audio gain and mute information.
The audio gain can be adjusted by steps of 0.75dB, 3dB or 6dB, in the range from
-77.25dB to +23.25dB of the current audio level.
The following screenshot shows the display of mute and audio gain settings:
Commands
The following table shows the various commands available to adjust the audio gain, and
mute an audio channel.
One of the following command can be applied on an individual channel when it is selected
and when the audio gain display is on.
Command description Command key
Hiding and Showing the audio gain display CTRL+G
Muting the selected audio channel CTRL+M
Un-muting the selected audio channel CTRL+U
Increasing by 0.75dB the audio level of the selected audio
channel SPACEBAR
Lowering by 0.75dB the audio level of the selected audio
channel SHIFT + SPACEBAR
Increasing by 3dB the audio level of the selected audio
channel CTRL+ARROW RIGHT
XT2 Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 118