Acer AB460 F1 - Manual (Page 283)

263
Installing/Removing a Switch
Module
Installing a Switch Module
1. Make sure the cover to the module has been installed before
proceeding. Follow the anti-static precautions described in
“Electrostatic discharge precautions” on page vii.
2. Remove the dummy cover from the bay you want to place the
module in.
3. Place the module's release handle in the open position.
4. Slide the module into the module bay until it stops (see the
following table).
Figure 4-163. Switch Module Location
5. Push the release handle to the closed position.
CAUTION CAUTION
CAUTION CAUTION
10G PORT
CX4 CX4 SFP
1G PORT IN
1G PORT IN
Stack ID RS232
3 2 1 4 3 2 1
RESET
1/10Gb Ethernet
Switch Modules