Acer AB460 F1 - Manual (Page 285)

265
Configuring the Switch Module
Figure 4-164. Configuring the Switch Module
A Gigabit Ethernet switch module can be configured using two
methods (as shown in Figure 4-164). You may configure it:
•
Through the Acer Smart Blade Console or Acer Smart Blade
Manager (via the CMM module)
• Directly through a command line (using a telnet interface or a
serial console)
The Acer Smart Blade Console and Acer Smart Blade Manager access
the switch module through the CMM module. To access it directly, use
the command line.
Note that any port may be configured as up (active) or down (inactive).
All ports are active by default.