Burkert Type 8056 - Manual (Page 32)

- 32 - RS232_485_ETP_MODBUS_BU_REV02.doc
Read command: NOT
SUPPORTED
1:CMD ERR if read command is
issued
5:ACCESS ERR if insufficient access
level
Set command: EPDCC=1 0:OK if execution ok
2:PARAM ERR if parameter not equal
to 1
EPDCC (Empty Pipe Detection
Calibration Command) Executes the
calibration of the empty pipe
detection circuit.
Help command: EPDCC=?
1:EXECUTE if accepted
Read command: SZPCC? 0 if the calibration is terminated
1 if the calibration is in progress
5:ACCESS ERR if insufficient access
level
Set command: SZPCC=1 0:OK if execution ok
2:PARAM ERR if parameter not equal
to 1
5:ACCESS ERR if insufficient access
level
SZPCC (Sensor Zero Point
Calibration Command) Executes the
calibration of the sensor zero point.
Help command: SZPCC=?
1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
Read command: NOT
SUPPORTED 1:CMD ERR if read command is
issued
5:ACCESS ERR if insufficient access
level
Set command: SZPCR=1 0:OK if execution ok
2:PARAM ERR if parameter not equal
to 1
5:ACCESS ERR if insufficient access
level
SZPCR (Sensor Zero Point
Calibration Reset) Resets the zero
point calibration value evaluated
with the preceding instruction
SZPCC.
Help command: SZPCR=? 1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
COMMANDS AND FUNCTIONS EQUIVALENT TO THE “2-SCALES” MENU
Name and description Modes Returned values or codes
Read command: FRMUT?
Value of measure unit if accepted
5:ACCESS ERR if insufficient access
level
Set command: FRMUT= n
0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
FRMUT (Flow Rate Measure Unit
Type) Reads or sets the type of
measure units relative to the flow
rate. Possible values are:
0:VM = Volume, Metric
1:WM = Weight, Metric
2:VI = Volume, Imperial or American
3:WI = Weight, Imperial or American
Help command: FRMUT=?
List of num:description if accepted
5:ACCESS ERR if insufficient access
level
Read command: FRMUV?
Value of measure unit if accepted
5:ACCESS ERR if insufficient access
level
Set command: FRMUV= n
0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
FRMUV (Flow Rate Measure Unit
Value) Reads or sets the value of
measure units relative to the flow
rate.
Help command: FRMUV=?
List of num:description if accepted
5:ACCESS ERR if insufficient access
level