Burkert Type 8056 - Manual (Page 44)

- 44 - RS232_485_ETP_MODBUS_BU_REV02.doc
Help command: IF2PT=? List of num:description if accepted
5:ACCESS ERR if insufficient access
level
Read command: DVADR? Device address if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Set command: DVADR= n 0:OK if parameters accepted
1:CMD ERR if RS232 port not enabled
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
DVADR (DeVice ADdRess) Reads
or sets the device address. Valid
only if the RS232 port is installed
and enabled.
Help command: DVADR=?
min <> max if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Read command: 232SP? RS232 speed if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Set command: 232SP= n 0:OK if parameters accepted
1:CMD ERR if RS232 port not enabled
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
232SP (rs232 SPeed) Reads or
sets the RS232 speed in bps. Valid
only if the RS232 port is installed
and enabled.
Help command: 232SP=?
List of num:description if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Read command: 232PT? RS232 protocol type if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Set command: 232PT= n 0:OK if parameters accepted
1:CMD ERR if RS232 port not enabled
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
232PT (rs232 Protocol Type)
Reads or sets the protocol type for
the RS232 port: it can be DPP or
HTP. Valid only if the RS232 port is
installed and enabled.
Help command: 232PT=? List of num:description if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
Read command: SEVSE?
Status of functions if accepted
5:ACCESS ERR if insufficient access
level
Set command: SEVSE = n 0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
SEVSE (Sms Event Send Enable)
Enable or disable event send by
SMS
Help command: SEVSE =?
List of num:description if accepted
5:ACCESS ERR if insufficient access
level
SPDSE (Sms Process Data Send
Enable) Enable or disable process
data send by SMS Read command: SPDSE?
Status of functions if accepted
5:ACCESS ERR if insufficient access
level