Burkert Type 8056 - Manual (Page 33)

- 33 - RS232_485_ETP_MODBUS_BU_REV02.doc
Read command: FRFS1?
Value of flow rate full scale 1 if accepted
5:ACCESS ERR if insufficient access
level
Set command: FRFS1= n
0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
FRFS1 (Flow Rate Full Scale 1)
Reads or sets the value of flow rate
full scale 1.
Help command: FRFS1=?
min <> max (units) if accepted
5:ACCESS ERR if insufficient access
level
Read command: FRFS2?
Value of flow rate full scale 2 if accepted
1:CMD ERR if full scale 2 not enabled
5:ACCESS ERR if insufficient access
level
Set command: FRFS2= n
0:OK if parameters accepted
1:CMD ERR if full scale 2 not enabled
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
FRFS2 (Flow Rate Full Scale 2)
Reads or sets the value of flow rate
full scale 2.
Help command: FRFS2=?
min <> max (units) if accepted
1:CMD ERR if full scale 2 not enabled
5:ACCESS ERR if insufficient access
level
Read command: VTMUT?
Type of measure unit if accepted
5:ACCESS ERR if insufficient access
level
Set command: VTMUT= n
0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
VTMUT (Volume Totalizer Measure
Unit Type) Reads or sets the type of
measure units relative to the
totalizers. Possible values are:
0:VM = Volume, Metric
1:WM = Weight, Metric
2:VI = Volume, Imperial or American
3:WI = Weight, Imperial or American
Help command: VTMUT=?
List of num:description if accepted
5:ACCESS ERR if insufficient access
level
Read command: VTMUV?
Value of measure unit if accepted
5:ACCESS ERR if insufficient access
level
Set command: VTMUV= n
0:OK if parameters accepted
2:PARAM ERR if n out of rang
5:ACCESS ERR if insufficient access
level
VTMUV (Volume Totalizer Measure
Unit Value) Reads or sets the value of
measure units relative to the
totalizers.
Help command: VTMUV=?
List of num:description if accepted
5:ACCESS ERR if insufficient access
level
Read command: VTDPP?
Value of decimal digits if accepted
5:ACCESS ERR if insufficient access
level
Set command: VTDPP= n
0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
VTDPP (Volume Totalizers Decimal
Point Position) Reads or sets the
value representing the number of
decimal digits for representing the
volume totalizers.
Help command: VTDPP=?
min <> max if accepted
5:ACCESS ERR if insufficient access
level