Burkert Type 8056 - Manual (Page 47)

- 47 - RS232_485_ETP_MODBUS_BU_REV02.doc
Help command: VTTPR=? 1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
Read command: NOT
SUPPORTED
1:CMD ERR if read command is
issued
5:ACCESS ERR if insufficient access
level
Set command: VTPPR=1 0:OK if parameters accepted
2:PARAM ERR if
n not equal to 1
5:ACCESS ERR if insufficient access
level
VTPPR (Volume Totalizer Partial
Positive Reset) Resets the partial
positive volume totalizer.
Help command: VTPPR=? 1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
Read command: NOT
SUPPORTED
1:CMD ERR if read command is
issued
5:ACCESS ERR if insufficient access
level
Set command: VTTNR=1 0:OK if parameters accepted
2:PARAM ERR if
n not equal to 1
5:ACCESS ERR if insufficient access
level
VTTNR (Volume Totalizer Total
Negative Reset) Resets the total
negative volume totalizer.
Help command: VTTNR=? 1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
Read command: NOT
SUPPORTED
1:CMD ERR if read command is
issued
5:ACCESS ERR if insufficient access
level
Set command: VTPNR=1 0:OK if parameters accepted
2:PARAM ERR if
n not equal to 1
5:ACCESS ERR if insufficient access
level
VTPNR (Volume Totalizer Partial
Negative Reset) Resets the partial
negative volume totalizer.
Help command: VTPNR=? 1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
Read command: ENSDT? Value of display on time if accepted
5:ACCESS ERR if insufficient access
level
Set command: ENSDT= n 0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
ENSDT (ENergy Saving Display
Time) Reads or sets the value of
the display on time used in the
energy saving mode. This time is
also used to wait for the incoming
of new sms if they are enabled.
Help command: ENSDT=?
min <> max (units) if accepted
5:ACCESS ERR if insufficient access
level
Read command: QSTME? Status of functions if accepted
5:ACCESS ERR if insufficient access
level
Set command: QSTME = n 0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
QSTME (Quick STart Menu
Enable)
Help command: QSTME =?
List of num:description if accepted
5:ACCESS ERR if insufficient access
level