Burkert Type 8056 - Manual (Page 56)

- 56 - RS232_485_ETP_MODBUS_BU_REV02.doc
Help command: SUDIC=? 1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
Read command: NOT
SUPPORTED
1:CMD ERR if command is issued SFDIC (Save Factory Defaults
Immediate Command) Saves the
current working parameters as
factory defaults preset data.
Help command: SFDIC=?
1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
Read command: NOT
SUPPORTED
1:CMD ERR if command is issued CMRIC (Complete Memory Reset
Immediate Command) Resets all
the working parameters to the
default values. WARNING: all the
current working parameters
eventually modified by the user
and the calibration coefficients
will be lost!
Help command: CMRIC=? 1:EXECUTE if accepted
5:ACCESS ERR if insufficient access
level
Read command: SRNUM? Value of serial number if accepted
5:ACCESS ERR if insufficient access
level
Set command: NOT
SUPPORTED 1:CMD ERR if command is issued
SRNUM (SeRial NUMber) Reads
the device serial number.
Help command: NOT
SUPPORTED
1:CMD ERR if command is issued
Read command: TONTM?
Value of total on time if accepted
Set command: NOT
SUPPORTED 1:CMD ERR if command is issued
TONTM (Total ON TiMe) Reads
the total functioning time of the
device.
Help command: NOT
SUPPORTED
1:CMD ERR if command is issued
Read command: CFFKT?
Value of the coefficient if accepted
5:ACCESS ERR if insufficient access
level
CFFKT (CoeFFicient KT) Reads or
sets the value of the gain coefficient
KT
Help command: CFFKT=?
min <> max if accepted
5:ACCESS ERR if insufficient access
level
Read command: CFFKR?
Value of the coefficient if accepted
5:ACCESS ERR if insufficient access
level
Set command: CFFKR= n 0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
CFFKR (CoeFFicient KR) Reads or
sets the value of the gain coefficient
KR
Help command: CFFKR=?
min <> max if accepted
5:ACCESS ERR if insufficient access
level
Read command: CFFKS?
Value of the coefficient if accepted
5:ACCESS ERR if insufficient access
level
Set command: CFFKS= n 0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
CFFKS (CoeFFicient KS) Reads or
sets the value of the gain coefficient
KS
Help command: CFFKS=? min <> max if accepted
5:ACCESS ERR if insufficient access
level