Burkert Type 8056 - Manual (Page 37)

- 37 - RS232_485_ETP_MODBUS_BU_REV02.doc
Help command: MFMXT=? min <> max (units) if accepted
5:ACCESS ERR if insufficient access
level
Read command: MFCUT? Value of measure cut-off thr. if
accepted
5:ACCESS ERR if insufficient access
level
Set command: MFCUT= n 0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
MFCUT (Measure Filter Cut-off
Threshold) Reads or sets the value
of the measure filter cut-off
threshold.
Help command: MFCUT=? min <> max (units) if accepted
5:ACCESS ERR if insufficient access
level
Read command: ACALE? Enable/disable status if accepted
5:ACCESS ERR if insufficient access
level
Set command: ACALE= n 0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
ACALE (Auto-CALibration Enable)
Enables or disables the auto-
calibration feature of the
instrument.
Help command: ACALE=?
List of num:description if accepted
5:ACCESS ERR if insufficient access
level
Read command: ARNGE?
Enable/disable status if accepted
5:ACCESS ERR if insufficient access
level
Set command: ARNGE= n 0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
ARNGE (Auto-RaNGe Enable)
Enables or disables the auto-range
feature of the instrument.
Help command: ARNGE=?
List of num:description if accepted
5:ACCESS ERR if insufficient access
level
Read command: ENSVE?
Enable/disable status if accepted
5:ACCESS ERR if insufficient access
level
Set command: ENSVE= n 0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
ENSVE (ENergy-SaVing Enable)
Enables or disables the energy-
saving feature of the instrument.
Help command: ENSVE=? List of num:description if accepted
5:ACCESS ERR if insufficient access
level
Read command: ENSST? Value of measure sampling time if
accepted
5:ACCESS ERR if insufficient access
level
Set command: ENSST= n 0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
ENSST (ENergy-Saving Sample
Time) Reads or sets the value of
the measure sampling time when
the energy-saving feature is active.
Help command: ENSST=? min <> max (units) if accepted
5:ACCESS ERR if insufficient access
level