Burkert Type 8056 - Manual (Page 43)

- 43 - RS232_485_ETP_MODBUS_BU_REV02.doc
Set command: CO1FS= n 0:OK if parameters accepted
1:CMD ERR if current output not
enabled
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
Help command: CO1FS=?
List of num:description if accepted
1:CMD ERR if current output not
enabled
5:ACCESS ERR if insufficient access
level
Read command: CO1SS? Start scale value if accepted
1:CMD ERR if current output not
enabled
5:ACCESS ERR if insufficient access
level
Set command: CO1SS= n 0:OK if parameters accepted
1:CMD ERR if current output not
enabled
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
CO1SS (Current Output 1 Start
Scale) Sets the start scale value
for the current output 1: it can be
0 or 4 mA. Valid only if the current
output1 is installed and enabled.
Help command: CO1SS=?
List of num:description if accepted
1:CMD ERR if current output not
enabled
5:ACCESS ERR if insufficient access
level
Read command: CO1FM?
Field mode for current output 1 if
accepted
1:CMD ERR if current output not
enabled
Set command: CO1FM= n 0:OK if parameters accepted
1:CMD ERR if current output not
enabled
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
CO1FM (Current Output 1 Field
Mode) Sets the field mode value
for the current output 1: it can be
+, -, +/-, –0+. Valid only if the
current output1 is installed and
enabled.
Help command: CO1FM=? List of num:description if accepted
1:CMD ERR if current output not
enabled
5:ACCESS ERR if insufficient access
level
COMMANDS AND FUNCTIONS EQUIVALENT TO THE “7-COMMUNICATION” MENU
Name and description Modes Returned values or codes
Read command: IF2PT?
Type of protocol if accepted
5:ACCESS ERR if insufficient access
level
IF2PT (IF2 Protocol Type) Reads
or sets the protocol type for the
IF2 port: it can be DPP or HTP.
Set command: IF2PT= n 0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level