Burkert Type 8056 User Manual
Page 34
- 34 -
RS232_485_ETP_MODBUS_BU_REV02.doc
Read command: CH1PV?
Value of volume pulse for channel 1
1:CMD ERR if channel 1 not enabled
5:ACCESS ERR if insufficient access
level
Set command: CH1PV=
n
0:OK if parameters accepted
1:CMD ERR if channel 1 not enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
CH1PV (CHannel 1 Pulse Value)
Reads or sets the value representing
the volume of one totalization pulse
for the channel 1.
Help command: CH1PV=?
min <> max
(units)
if accepted
1:CMD ERR if channel 1 not enabled
5:ACCESS ERR if insufficient access
level
Read command: CH2PV?
Value of volume pulse for channel 2
1:CMD ERR if channel 2 not enabled
5:ACCESS ERR if insufficient access
level
Set command: CH2PV=
n
0:OK if parameters accepted
1:CMD ERR if channel 2 not enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
CH2PV (CHannel 2 Pulse Value)
Reads or sets the value representing
the volume of one totalization pulse
for the channel 2.
Help command: CH2PV=?
min <> max
(units)
if accepted
1:CMD ERR if channel 2 not enabled
5:ACCESS ERR if insufficient access
level
Read command: CH1PT?
Value of pulse time for channel 1
1:CMD ERR if channel 1 not enabled
5:ACCESS ERR if insufficient access
level
Set command: CH1PT=
n
0:OK if parameters accepted
1:CMD ERR if channel 1 not enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
CH1PT (CHannel 1 Pulse Time)
Reads or sets the value representing
the time duration pulse for the
channel 1.
Help command: CH1PT=?
min <> max
(units)
if accepted
1:CMD ERR if channel 1 not enabled
5:ACCESS ERR if insufficient access
level
Read command: CH2PT?
Value of pulse time for channel 2
1:CMD ERR if channel 2 not enabled
5:ACCESS ERR if insufficient access
level
Set command: CH2PT=
n
0:OK if parameters accepted
1:CMD ERR if channel 2 not enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
CH2PT (CHannel 2 Pulse Time)
Reads or sets the value representing
the time duration pulse for the
channel 2.
Help command: CH2PT =?
min <> max
(units)
if accepted
1:CMD ERR if channel 2 not enabled
5:ACCESS ERR if insufficient access
level
VMSGC (Volume to Mass Specific
Gravity Coefficient) Reads or sets the
value representing the transformation
coefficient between volume and mass.
Read command: VMSGK?
Value of volume-to-mass coefficient
1:CMD ERR if weight units not enabled
5:ACCESS ERR if insufficient access
level