Burkert Type 8056 User Manual
Page 40
- 40 -
RS232_485_ETP_MODBUS_BU_REV02.doc
Set command: VTPPE=
n
0:OK if parameters accepted
1:CMD ERR if digital input not
enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
on the digital input. Valid only if
the digital input is installed and
enabled.
Help command: VTPPE=?
List of
num:description
if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
Read command: VTTNE?
Status of reset consent if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
Set command: VTTNE=
n
0:OK if parameters accepted
1:CMD ERR if digital input not
enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
VTTNE (Volume Totalizer Total
Negative reset Enable) Enables or
disables the consent for resetting
the total negative volume totalizer
when receiving an external signal
on the digital input. Valid only if
the digital input is installed and
enabled.
Help command: VTTNE=?
List of
num:description
if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
Read command: VTPNE?
Status of reset consent if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
Set command: VTPNE=
n
0:OK if parameters accepted
1:CMD ERR if digital input not
enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level
VTPNE (Volume Totalizer Partial
Negative reset Enable) Enables or
disables the consent for resetting
the partial negative volume
totalizer when receiving an
external signal on the digital input.
Valid only if the digital input is
installed and enabled.
Help command: VTPNE=?
List of
num:description
if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
Read command: TCLIE?
Status of locking consent if accepted
1:CMD ERR if digital input not
enabled
5:ACCESS ERR if insufficient access
level
TCLIE (Totalizers Count Lock
Input Enable) Enables or disables
the consent for locking the
totalizers when receiving an
external signal on the digital input.
Valid only if the digital input is
installed and enabled.
Set command: TCLIE=
n
0:OK if parameters accepted
1:CMD ERR if digital input not
enabled
2:PARAM ERR if
n
out of range
5:ACCESS ERR if insufficient access
level