Burkert Type 8056 - Manual (Page 46)

- 46 - RS232_485_ETP_MODBUS_BU_REV02.doc
Read command: GSCLN? Status of functions if accepted
5:ACCESS ERR if insufficient access
level
Set command: GSCLN = n 0:OK if parameters accepted
2:PARAM ERR if n out of range
5:ACCESS ERR if insufficient access
level
GSCLN (GSm CaLl Number)
telephone number for GSM
connection
Help command: GSCLN =?
MAX 31 CHR STRING if accepted
5:ACCESS ERR if insufficient access
level
Read command: 485PT?
RS485 protocol type if accepted
1:CMD ERR if RS485 port not enabled
5:ACCESS ERR if insufficient access
level
Set command: 485PT = n 0:OK if parameters accepted
1:CMD ERR if RS485 port not enabled
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
485PT (RS485 Protocol Type)
Reads or sets the protocol type for
the RS485 port: it can be DPP, HTP
or MODBUS. Valid only if the RS485
port is installed and enabled
Help command: 485PT =? List of num:description if accepted
1:CMD ERR if RS485 port not enabled
5:ACCESS ERR if insufficient access
level
Read command: MODBP?
RS485 parity if accepted
5:ACCESS ERR if insufficient access
level
Set command: MODBP= n 0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
MODBP (MODBus Parity) parity
control in MODBUS protocol
Help command: MODBP=? List of num:description if accepted
1:CMD ERR if RS232 port not enabled
5:ACCESS ERR if insufficient access
level
COMMANDS AND FUNCTIONS EQUIVALENT TO THE “8-DISPLAY” MENU
Name and description Modes Returned values or codes
Read command: LLANG?
Layout language if accepted
5:ACCESS ERR if insufficient access
level
Set command: LLANG= n 0:OK if parameters accepted
2:PARAM ERR if
n out of range
5:ACCESS ERR if insufficient access
level
LLANG (Layout LANGuage)
Reads or sets the layout language
used for all the display messages.
Help command: LLANG=? List of num:description if accepted
5:ACCESS ERR if insufficient access
level
Read command: NOT
SUPPORTED
1:CMD ERR if read command is
issued
5:ACCESS ERR if insufficient access
level
VTTPR (Volume Totalizer Total
Positive Reset) Resets the total
positive volume totalizer.
Set command: VTTPR=1 0:OK if parameters accepted
2:PARAM ERR if
n not equal to 1
5:ACCESS ERR if insufficient access
level