Clear-Com HX System Frames - Manual (Page 222)

8.2.1 Save to EHX configuration and exit
1) Click on this button to save the audio mixer setup to the current EHX
configuration. When in Online mode clicking on this button also saves the audio
mixer settings into the current EHX configuration. After the setup has been saved
the audio mixer automatically exits back to panel programming.
Online Mode
2) Click on this button to allow audio mixer settings to be sent to the panel
immediately without the need to save to the configuration and download a new
map.
When the Online button is pressed it flashes amber/green and the mixer pane background
changes to amber while EHX contacts the matrix and uploads the current audio settings
for the selected panel. If the button and audio mixer pane background remain amber (see
Figure 8-2 Online Mode Waiting for Reply below) this indicates that EHX was unable to
obtain the current panel audio settings from the matrix (the panel may not be connected to
the matrix).
It may take a few seconds for EHX to obtain the panel details from the matrix.
Figure 8-2 Online Mode Waiting for Reply
When the settings have been loaded the button and audio mixer pane background turns
green to indicate that the settings may be adjusted (see Figure 8-3 Online Mode
Connected and Ready ).
222 Eclipse EHX Software User Guide