Clear-Com HX System Frames - Manual (Page 44)

Option Description
Empty Configuration If this option is selected the matrix is added and
the Hardware, Configuration and Diagnostic
menu links are displayed in the menu pane. The
Hardware link flashes amber if no cards or
panels have been configured.
The matrix IP address and system preferences
are set up as described below, after which the
hardware should be configured manually.
Discover Hardware Select this option to fully and automatically
populate the project with available cards and
panels.
A progress bar is displayed while the hardware
is being discovered (see below). The matrix is
added to the project and the Hardware,
Configuration and Diagnostic menu links are
displayed in the left hand menu pane.
Upload Configuration from Matrix This option is a backup facility that enables you
to retrieve the last downloaded configuration
from the matrix (provided one has been loaded).
It is not a general way to configure the matrix.
Once the configuration has been loaded the
Hardware, Configuration and Diagnostics
menu links are displayed and the configuration
(which already contains the system and panel
setups) can be edited.
Table 3-2 Add Matrix to Project Dialog
3.5.3 Matrix preferences menu
To configure the global system settings of a matrix:
1) From the System pane, select the matrix, and then from the Menu pane, select
Configuration > Preferences.
The settings are organised under a series of tabs.
44 Eclipse EHX Software User Guide