Clear-Com HX System Frames - Manual (Page 33)

5) Remove the master CPU card.
6) Press and hold the ENG and FULL RESET front panel buttons simultaneously
(bottom of card) then press the RESET button (top of card, see Figure 3-1) on the
slave CPU card.
7) Replace the master CPU card.
8) Ensure that the matrix and the EHX PC are connected using an ethernet
connection, either directly or over a network.
9) Configure the ethernet connection on the EHX PC, then create a configuration
with the factory default IP address.
10) Download the complete configuration map to the matrix, using the factory default
IP address.
33 Eclipse EHX Software User Guide