Panel and key operation, Tally settings – Clear-Com HX System Frames User Manual
Page 50
To configure the DECT frequency:
1)
Click Configure, and enter the DECT configuration password to display the
DECT configuration screen (Select Frequency Region).
Figure 3-22 Select Frequency Region
The frequency range used by the wireless beltpacks can be set:
• Directly by entering the required value into the field.
• By selecting the appropriate region, using the radio buttons.
• By selecting the country where the wireless system is used from the drop-
down menu.
If you use either of the last two options, the correct frequency range value is
automatically inserted.
2)
To confirm the frequency range, click OK.
Panel and key operation
Use this tab to control the incoming audio signalization (tally) key color of keys and rotary
encoders on panels connected to Eclipse HX matrices.
Figure 3-23 Key Operation Tab
Tally settings
Use this section to change the incoming Tally light color (the default is red). The options
are:
• Red. Tally light color is red
• Green. Tally light color is green (I-Series only).
50
Eclipse EHX Software User Guide