Multichannel Systems Roboinject Manual - Manual (Page 24)

Roboinject Manual
20
Settings
Menu for setting options and for defining directories.
Click "Options" in main menu "Settings". The "Options" dialog has four tabs.
Click "General" tab.
The dialog allows general settings concerning two general software features,
and the "Test Injection Dialog" in particular.
Enable the check box "Auto increment plate ID", if you want that the plate ID
is automatically counted up when creating a new file.
Enable the check box "Reset / Remove Microscope dialog" if you want to see
the “Remove Microscope” dialog after alignment again.
The “Test Injection” dialog appears immediately before the injection run of each sample
if selected in the "Sample Information" dialog. This allows the user to execute a test
injection before starting the injection run or to stop the injection run completely.
With regard to the "Test Injection Dialog" you can select or deselect the two check boxes
"Enable Auto Close" and "Beep before dialog closes". Additionally you can choose
the time span for displaying the "Test Injection Dialog" from the drop down menu.
The "Auto close time" varies from 30 to 180 seconds.