Edwards Signaling FSC Series - Manual (Page 41)

Chapter 3: Panel programming
FSC Series Technical Reference Manual 33
RRM Multi Mode: Determines how relays on an FSRRM24 configured for
programmable operation (jumper installed on JP2) are programmed. The values
that you can select are:
• Common Alarm: Relays are automatically programmed to energize on any
alarm event.
• Matrix: You must program an initiating device circuit to activate the relays.
Table 11: Panel program options
Step Option Values
LCD first line ALARM TROUBLE SUP POWER DISABLE LCD second line WATERFLO
W
ANN TROUBL
E
BATT TROUBLE GND FAULT SERVICE DETECTOR
1 Load Defaults      No (default)     
Yes     
2 Edit Passcode [3]      1111 (default) to FFFF     
3 Enable Passcode [2]      No (default)     
Yes     
4 Panel Op Mode [2]      FACP (default)     
FACOM     
Sprinkler Supv     
5 Rst/Sil Inhibit      None (default)     
1 minute     
6 AC Fail Delay      0 hours     
1 hour     
2 hours     
3 hours (default)     
4 hours     
5 hours     
6 hours     
7 hours     
8 hours     
9 hours     