Innotech Genesis II Digital Controller (v5) - Manual (Page 14)

Genesis II Installation Instructions
Page 14 © Mass Electronics Pty Ltd 2010 Edition 2.0 dated 06/12/2013
1-2 Special Considerations
The following precautions and installation considerations must be observed to ensure personal
safety and to prevent damage to equipment:
• Local safety regulations, building codes and ordinances must be complied with during
installation. In cases of conflict with procedures in this manual, contact Innotech or its authorised
representative for clarification.
• To prevent damage to equipment, avoid applying electrical power to the equipment prior to
checkout, unless specifically instructed to do so in this manual.
• The Genesis II System can be installed using common tools and test equipment. Only qualified
personnel familiar with local codes and practices should install the system. Wiring should only be
performed by someone knowledgeable of electronics and wiring installation practices. Refer to
the appropriate documentation when installing items provided by other manufacturers.
1-3 Unpacking Instructions
The following unpacking instructions should be followed as soon as possible after the equipment is
delivered to the installation site:
1. Carefully unpack each item and set packing materials aside for future use.
2. Check the inventory against the packing list to make sure nothing is missing.
3. Inspect each item for damage.
4. Report any shortages or damaged items.
5. Collect all factory inspection sheets and similar data; place in an equipment history file.
6. Any items which are not installed immediately should be carefully returned to its shipping
container and stored in a safe place until it is time for it to be installed.
1-4 Installation Plans
The following installation data should be gathered and made available to the installation team:
• This technical manual.
• Computer-Generated Wiring Diagram: the Innotech Gen2Config software can be used to print a
wiring diagram for the specific application. A copy of this wiring diagram is usually provided at
the time of hardware delivery. Procedures for printing additional copies of the wiring diagram are
contained in the Gen2Config Online Help.
• Computer-Generated Materials List: the Materials List is also provided at the time of hardware
delivery. The list is printed out from the Innotech Gen2Config software. The Materials List shows
all the items of hardware required for the specific application.
• For non-Innotech equipment, gather the manufacturer’s installation-related data such as
schematics, wiring diagrams, dimension diagrams, etc.
• Any other data source as it becomes known.
1-5 Tools and Test Equipment
No special tools are required for installation of the Genesis II Systems. Only common hand tools
are needed. A high impedance digital Volt-Ohm-Milliammeter is the only item of electronic test
equipment required.