Innotech Genesis II Digital Controller (v5) - Manual (Page 19)

Page 19
Genesis II Installation Instructions
© Mass Electronics Pty Ltd 2010 Chapter 2 – Mechanical Installation
2-2.2 Remote Expansion Modules
Remote Expansion Modules increase the capability of a controller by allowing more input and output
devices to be connected to it.
The term Remote Expansion Module (REM) is the collective term applied to several types of units
used to configure the hardware to the customer's requirements. The following paragraphs contain
wiring information for the following categories of REMs used in the Genesis II System:
• REM I/O Expansion Modules ( 2-2.2.1 )
• REM Control Station Modules ( 2-2.2.2 )
• REM Multi Zone Station Modules ( 2-2.2.3 )
• REM Multipoint Modules ( 2-2.2.4 )
• REM Wireless Sensor Modules ( 2-2.2.5 )
The system imposes restrictions on the total number and types of REMs that can be used with a
controller. These requirements are explained in section 2-4.1 .
2-2.1.2 MPC II Mid Points Controller
The Innotech MPCII Mid Points Controller is a state-of-the-art processing system that has the
capability of controlling various types of industrial systems. The MPCII Mid Points Controller can be
used in a Genesis II System as the main controller.
It is housed in a case suitable for Switchboard Mounting. The housing is moulded from flame
retardant plastics recognised by UL as UL 94-V0. The MPCII Mid Points Controller does not have any
external controls or indicators. Refer to Figure 2-3.
GENESIS MPC
DIGI TAL C O NTROLLER
163
188 65
Figure 2-3: MPCII Mid Point Controller Dimensions