Innotech Genesis II Digital Controller (v5) - Manual (Page 32)

Genesis II Installation Instructions
Page 32 © Mass Electronics Pty Ltd 2010 Edition 2.0 dated 06/12/2013
3-1 Introduction
This section of the manual contains instructions and related data to facilitate the electrical
installation of the Genesis II System. Because of the designed-in flexibility of the Genesis II System,
it can be installed in a wide variety of configurations, depending on the user’s preference. For this
reason, it is not possible to include all the various installation configurations in this manual. Instead,
this manual provides examples of typical installations.
Innotech recognises that the installation examples described in this manual may not be in total
agreement with the user’s requirements. However, information in this document should be used as
a guide for all installations, regardless of whether the specific circumstances match the examples
given. In all cases, installation personnel should familiarise themselves with the information
contained in this section.
3-2 Electrical Installation Practices
This paragraph provides general information which is intended to assist qualified personnel installing
the Genesis II Systems. More detailed information for wiring of controllers and expansion modules
is contained in subsequent paragraphs. All wiring between the controller/expansion modules and
system input/output devices, such as sensors, fans and compressors, must be in accordance with the
instructions in the applicable instruction manual or datasheet.
If required, additional installation recommendations can be provided from Innotech Control Systems Australia upon
request.
NOTE
This section of the technical manual contains the following specific information:
• Electrical Installation Practices of a general nature
• Wiring information for digital controllers (Genesis II Direct Digital Controller, MPCII Mid Points
Controller)
• Wiring information for Remote Expansion Modules
If any data presented in this manual disagrees with information in the applicable instruction manual, information
in the manufacturer’s instruction manual takes precedence. Customers are encouraged to contact Innotech
Control Systems Australia for further information or clarification of information presented herein via the contact
details at the back of this document.
NOTE
Electrical power to the system must be turned off throughout the installation process. Do not apply power to any
part of the system until ready for Commissioning (see Commissioning ).
CAUTION