Innotech Genesis II Digital Controller (v5) - Manual (Page 43)

Page 43
Genesis II Installation Instructions
© Mass Electronics Pty Ltd 2010 Chapter 3 – Electrical Installation
3-3.2 MPCII Mid Points Controller
Figure 3-4 shows the input/output connection groups for the MPCII Mid Points Controller. The MPCII
Mid Points Controller uses terminal strips located around the controller’s perimeter. Terminals are
grouped by function as follows:
• Power Input ( 3-3.2.1 )
• Digital Inputs ( 3-3.2.2 )
• Digital Outputs ( 3-3.2.3 )
• Analogue Inputs ( 3-3.2.4 )
• Analogue Outputs ( 3-3.2.5 )
• Remote Expansion Modules (REM) Connector ( 3-3.2.6 )
• RS232 Serial Communications (Comms) Port ( Network Installation )
• Net & Global Communications (Comms, RS485) Terminal ( Network Installation )
RS
-232 COMMS
COMMS
NET
COMMS
REM
GLOBAL
COMMS
MPC
Cobar
POWER
DIGITAL INPUTS
SCREENS
ANALOGUE INPUTS
RS232
CONNECTOR
REM
PORT
RS485
COMMS
ANALOGUE
OUTPUTS
DIGITAL OUTPUTS
Figure 3-4: MPCII Mid Points Controller Input / Output Terminals