Innotech Genesis II Digital Controller (v5) - Manual (Page 22)

Genesis II Installation Instructions
Page 22 © Mass Electronics Pty Ltd 2010 Edition 2.0 dated 06/12/2013
2-2.2.3 REM Multi Zone Station Modules
REM Multi Zone Station Modules are housed in a switchplate that mounts in standard electrical
wall plates at a remote location. Mechanical installation instructions for the REM Multi Zone Station
Modules are not applicable; electrical installation instructions for these modules are contained in the
Electrical Installation chapter.
There are a total of two different REM Multi Zone Station Modules.
• GENII MZS REM Multi Zone Station Module
• GENII MZSAH REM Multi Zone Station A/H Module
Common Enclosure Information
Colour: White
Mounting: Wall Mounted
The cable run between a digital controller and REM Multi Zone Station Modules should not exceed
600 metres. However, the maximum cable length can be increased through the use of Innotech
Repeater IR11 module. Refer to Paragraph 5-3.3.3 for more information.
Below is a schematic of the GENII MZS REM Multi Zone Station Module. The above listed REM Control
Station Modules feature the same dimensions and similar appearance. Refer to Figure 2-6.
Run Select
1
2
3
4
5
6
On
Off
Figure 2-6: GenII MZS REM Multizone Station Module