Rockwell Automation 1395 Multi-Comm Hardware/Software - Manual (Page 140)

Table of Contents
8–45
Parameter 462 – [A>ChB DH Out 4]
Parameter 362 – [B>ChB DH Out 4]
Use: Channel B DH+ output word #4
Parameter Type: Fast Sink
Program Terminal Units: None
Minimum Value:
Maximum Value:
Default Value: None
Description: This parameter is a fast sink that provides data to other
devices on the network through the DH+ message instruction. The node
address is determined by the DIP switch settings for channel B. The data
to be attached is determined by the configuration link made to this
parameter.
Parameter 463 – [A>ChB DH Out 5]
Parameter 363 – [B>ChB DH Out 5]
Use: Channel B DH+ output word #5
Parameter Type: Configuration
Program Terminal Units: None
Minimum Value:
Maximum Value:
Default Value: None
Description: This parameter is a fast sink that provides data to other
devices on the network through the DH+ message instruction. The node
address is determined by the DIP switch settings for channel B. The data
to be attached is determined by the configuration link made to this
parameter.
Parameter 575 – [A>ChA DH Rd Nde1]
Parameter 525 – [B>ChA DH Rd Nde1]
Use: Channel A Read Station Number 1
Parameter Type: Setup
Program Terminal Units: None
Minimum Value: 0
Maximum Value: 77
Default Value: 8
Description: Each node address can add two words of data to the global
data table which is passed with the network token. The data is then
available to other nodes on DH+ by specifing the originating node address
and the desired word. This parameter specifies which node address the
DH TP In 1 parameter will receive its data from. The node address is
entered in octal so that it corresponds with the node addressing scheme of
DH+. The default value of 8 disables the data transfer.