Rockwell Automation 1395 Multi-Comm Hardware/Software - Manual (Page 62)

Chapter 3
Configuration & Interfacing
3–51
BTR
NOTE: Word 4 of the BTR instruction is
broken down into two bytes. The High
byte contains the status bits per Table
3–H. The low byte contains the Drive
message length in bytes.
0
0
See Table
48
Parameter #(x50)
Parameter #(x51)
Parameter #(x52)
•
Parameter #(x69)
The “x” designator is a position holder. It could represent
parameter 150, 250, 350, etc. depending on which configura-
tion table is being requested.
Message Operation – The UPLOAD CONFIGURATION TABLE
function requests a listing of the Drive configuration links from the Drive
for use in the PLC Controller. This command is broken down into five
groups of tables.