Rockwell Automation 1395 Multi-Comm Hardware/Software - Manual (Page 59)

Chapter 3
Configuration & Interfacing
3–48
Drive System Reset
This function causes the Drive to do a “warm boot restart”. Any data in
Drive memory at the time the command is issued is erased and is not saved
in EEPROM.
PLC Block Transfer Data –
BTW Instruction Length: 4
PLC DH+ Data –
Write
Size In Elements: 4
Processor Type: PLC–5
Destination Address: N15:0–3
Message Structure –
Message Header Information:
Word 1: 0
Word 2: 0
Function Code, Word 3: 1539
Write Message Length, Word 4: 8 bytes
WORD
BTW
1
2
3
4
NOTE: Word 4 of the BTR instruction is broken down into
two bytes. The High byte contains the status bits
per table 3–H. The low byte contains the Drive
message length in bytes.
0
0
1539
8
Message Operation – The DRIVE SYSTEM RESET function causes the
Drive to reboot all processors. This is the same sequence that the Drive
goes through when power is first applied.
IMPORTANT: Any parameter data or configuration links that were not
stored in EEPROM prior to the Drive receiving this command will be
erased.
This function requires the message header only. The Drive will not
provide a response message to this command.