Compex Systems Advanced SerialRAID Adapters SA33-3285-02 - Manual (Page 117)

Using Other Configuration Functions
This part of the chapter describes the maintenance procedures that are available for
your Advanced SerialRAID Adapter. You can use these procedures at any time. You can
get to the required SMIT menu by using fast path commands or by working through
other menus.
Notes:
1. Although this book always refers to the smitty commands, you can use either the
smitty command, or the smit command. The procedures that you follow remain the
same, whichever of the two commands you use. If you send the smit command
from a graphics terminal, however, the menus are displayed slightly differently from
those shown in this book. If you are not familiar with the selection of items from the
graphics versions of the menus, use the smitty command. The menus will then
appear as shown in this book.
2. If you use fast-path commands, you might need to go through intermediate steps
that are not shown in this book. Also, some menus might be displayed slightly
differently from those shown in this book.
Chapter 6. Using the RAID Array Configurator 97