Compex Systems Advanced SerialRAID Adapters SA33-3285-02 - Manual (Page 343)

9. The following information is displayed:
Remove a Disk from an SSA RAID Array
Type or select values in entry fields.
Press Enter AFTER making all desired changes.
Entry Fields
SSA RAID Manager ssa0
SSA RAID Array hdisk3
Connection Address / Array Name 095231779F0737K
* Disk to Remove +
F1=HelpF2=Refresh F3=Cancel F4=List
F5=Reset F6=Command F7=Edit F8=Image
F9=Shell F10=Exit Enter=Do
Press F4 to list the disk drives.
10. A list of disk drives is displayed.
From the displayed list, select the disk drive that you want to remove.
11. If necessary, use the Identify function to find the disk drive that you want to remove
(see “Finding the Physical Location of a Device” on page 409).
12. Press Enter to remove the disk drive from the array.
13. If the Check light of the disk drive that you are removing is off, use the Set Service
Mode service aid to put that disk drive into Service Mode (see “Set Service Mode
Service Aid” on page 378).
If the Check light of the disk drive that you are removing is on, you do not need to
select Service Mode before you remove that disk drive.
14. Physically remove the disk drive. (See the service information for the device that
contains the disk drive, then return to here.)
15. Physically install the replacement disk drive. (See the service information for the
device that contains the disk drive, then return to here.)
16. If the disk drive is in Service Mode, reset Service Mode. (See “Set Service Mode
Service Aid” on page 378, then return to here.)
Chapter 15. Removal and Replacement Procedures 323