Compex Systems Advanced SerialRAID Adapters SA33-3285-02 - Manual (Page 78)

Installing and Configuring SSA RAID Arrays
You can get to the required SMIT menu by using fast path commands, or by working
through other menus. In this chapter, the fast path command for a particular option is
given at the start of the description of that option.
Notes:
1. Although this book always refers to the smitty commands, you can use either the
smitty command, or the smit command. The procedures that you follow remain the
same, whichever of the two commands you use. If you send the smit command
from a graphics terminal, however, the menus are displayed slightly differently from
those shown in this book. If you are not familiar with the selection of items from the
graphics versions of the menus, use the smitty command. The menus will then
appear as shown in this book.
2. Different microcode levels might cause slightly different versions of the menus to be
displayed.
3. If you use fast-path commands, you might need to go through intermediate steps
that are not shown in this book. Also, some menus might be displayed slightly
differently from those shown in this book.
58 User’s Guide and Maintenance Information
|
|