Compex Systems Advanced SerialRAID Adapters SA33-3285-02 - Manual (Page 259)

Examples
For the examples given here, assume that the following items of hardware are available
in the system:
v A RAID Manager named ssa0
v Four SSA physical disks named pdisk0, pdisk1, pdisk2, and pdisk3
Example 1: To Create a RAID-0 Array
This example shows how to use three SSA physical disks to create a RAID-0 array. The
attributes of the disks are all set to their default values.
Type the command:
> ssaraid -C -l ssa0 -t raid_0 -s pdisk0 pdisk1 pdisk2 -d
where:
-C specifies that this operation is a create operation.
-l ssa0 specifies that RAID Manager ssa0 is to be used.
-t raid_0 specifies that a RAID-0 array object is to be created.
-s pdisk... specifies the free pdisk that is to become the member disk of the new
array.
-d specifies that a system disk is to be attached to the new array.
Example 2: To Create a RAID-1 Array
This example shows how to use two SSA physical disks to create a RAID-1 array. The
attributes of the disks are all set to their default values.
Type the command:
> ssaraid -C -l ssa0 -t raid_1 -s pdisk0 pdisk1 -d
where:
-C specifies that this operation is a create operation.
-l ssa0 specifies that RAID Manager ssa0 is to be used.
-t raid_1 specifies that a RAID-1 array object is to be created.
-s pdisk... specifies the free pdisk that is to become the member disk of the new
array. RAID-1 arrays provide support for only two member disk drives. The first disk
drive that is specified becomes the primary member disk drive.
-d specifies that a system disk is to be attached to the new array.
Chapter 12. Using the SSA Command Line Interface for RAID Configurations 239
|
|