Rice Lake Static Weighing - Manual (Page 34)

30 CW-90/90X Checkweigher
SETUP Menu
Parameter Choices Description
Level 2 submenus
SCALE See Section 3.4.1 on
page 18 Configure scale settings. See the level 3 submenus of Table 3-4 on page 19 for parameter
descriptions.
FEATUR See Section 3.4.2 on
page 23 Set checkweighing options, region settings, view Unit ID, and set consecutive numbering.
See level 3 submenus of Table 3-5 on page 24 for parameter descriptions.
SERIAL PORT 1
PORT 2
PORT 3 (Option Card) Configure communications ports. See level 3 submenus below for parameter descriptions.
PFORMT GFMT
NFMT
ACCFMT
STRM.FM
BUF.FMT
H1
H2 Sets the print format for gross weight, net weight, accumulated weight, stream, buffer,
Header 1 and Header 2.
DIG IO DIO 1
DIO 2
DIO 3
DIO 4 Assign digital input/output functions.
VERS SOFTWR
REG
DEFALT Displays the software version.

Displays the regulatory version.

Restores settings to their default values.
Level 3 submenus
PORT 1 TRIGGE
PRNMSG
BAUD
BITS
STOP B
TERMIN
EOLDLY
ECHO Specifies Port 1’s mechanism for triggering a transmission of data, print message, baud
rate, bits, stop bits, termination character, end-of-line delay, and echo.See level 4
submenu for parameter descriptions.
Note
If any port is set to PRNMSG=ON, PRINT will display.
PORT 2 TRIGGE
PRNMSG
BAUD
BITS
STOP B
TERMIN
EOLDLY
ECHO Specifies Port 2’s mechanism for triggering a transmission of data, print message, baud
rate, bits, stop bits, termination character, end-of-line delay, and echo.See level 4
submenu for parameter descriptions.
Note
If any port is set to PRNMSG=ON, PRINT will display.
PORT 3 TRIGGE
PRNMSG
BAUD
BITS
STOP B
TERMIN
EOLDLY
ECHO Specifies Port 3’s mechanism for triggering a transmission of data, print message, baud
rate, bits, stop bits, termination character, end-of-line delay, and echo.See level 4
submenu for parameter descriptions.
Note
If any port is set to PRNMSG=ON, PRINT will display.
SOFTWR V 1.00 Displays the software version.
REG LR,V.1.00 Displays the legally relevant version.
DEFALT NO
YES Resets settings to default values if YES is selected.
Table 3-7. Serial, PFORMT, DIG I/O, VERS Submenu Parameters