Rice Lake Static Weighing - Manual (Page 55)

Serial Commands 51
EDP.STOPBITS#p Port stop bits 2, 1
EDP.PRNMSG#P Print message ON, OFF
EDP.ECHO#p Port echo ON, OFF
EDP.EOLDLY#p Port end-of-line delay 0–255 (0.1-second intervals)
EDP.TRIGGER#x Port trigger DEMAND, STREAM, COMAND, WAITSS, TARGET, L-STAB, OFF
STR.POS Custom stream identifiers None, Space, +
STR.NEG None, Space, +
STR.PRI 8 alphanumeric characters
STR.SEC 8 alphanumeric characters
STR.TER 8 alphanumeric characters
STR.GROSS 8 alphanumeric characters
STR.NET 8 alphanumeric characters
STR.TARE 8 alphanumeric characters
STR.MOTION 2 alphanumeric characters
STR.RANGE 2 alphanumeric characters
STR.OK 2 alphanumeric characters
STR.INVALID 2 alphanumeric characters
STR.ZERO
Command Description Values
BUFFER Turns buffer off or on OFF, PORT 1, PORT 2, PORT 3
MODE Sets checkweighing mode RANGE, TARGWT, TARG%
VALSET Value set KEYED, PUSH, BOTH, RDONLY
NEGCKW Sets negative checkweighing OFF, ON, AUTO
ID Turns IDs off or on OFF, ON
LIGHTS Sets the lights display SOLID, GRAPH, OFF
CFGPWD Configuration password 0, 1–9999999
CONSNUM Consecutive numbering 0–9999999
CONSTUP Consecutive number start-up value 0–9999999
DATEFMT Date format MMDDYYYY, DDMMYYYY, YYYYMMDD, YYYYDDMM
DATESEP Date separator SLASH, DASH, SEMI
DECFMT Decimal format DOT, COMMA
DSPBRIGHT Sets display intensity 0 (dimmest), 1, 2, 3, 4, 5, 6, 7 (brightest)
KYBDLK Keyboard lock (disable keypad) OFF, ON
REGULAT Regulatory compliance NONE, OIML, NTEP, CANADA, INDUST
REG.HLDWGH Allow weighment during display
hold NO, YES
REG.CTARE Allow clear keyed tare NO, YES
REG.HTARE Allow tare in display hold NO, YES
REG.KTARE Always allow keyed tare NO, YES
REG.MTARE Multiple tare action REPLACE, REMOVE, NOTHING
REG.NTARE Allow negative tare NO, YES
Table 6-6. FEATURE Serial Commands
Command Description Values
Table 6-5. SERIAL Port Serial Commands (Continued)