Rice Lake Signal Conditioning Transmitter/Indicators - Manual (Page 48)

44 SCT Weight Transmitter Operator’s Manual
3.9 SCT20-TCP/IP (Ethernet TCP/IP)
To configure Ethernet TCP/IP port of SCT20-TCP/IP, the Lantronix DeviceInstaller must be installed on a
Windows PC (launch DevInst.exe on the CD to install it).
1. Connect the PC and SCT20-TCP/IP through a LAN (point-to-point or with hub/switch), and then launch
the Lantronix DeviceInstaller.
2. Select the
Search
button and the application will find the SCT20-TCP/IP in the LAN.
Figure 3-1. Find SCT20-TCP/IP in LAN
3. Select the device and then select the
Telnet Configuration
.
4. Select the
Connect
button and then press Enter.
5. Press
0 [Server]
and change only IP Address four fields (don’t change other parameters: press
Enter
to
confirm). It is strongly recommended to set a fixed IP Address.
6. Press
1 [Channel 1]
if you want to change serial BaudRate of the Ethernet Module to match the BaudRate
set in SCT20-TCP/IP Protocol Selection (default 9600) (don’t change other parameters: press
Enter
to
confirm.
EtherNet TCP/IP