Handling the digital audio input signal, 2) handling the clock signal, Word clock – Yamaha DEQ5 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Handling the digital audio input signal
(1) Input setting
The unit is provided with 2 systems (AES/EBU and Y2) of digital system input terminals except for XLR type
analog I/O terminal. When handling signals from these input terminals, the input system should be designated
with the “UTILITY” menu.
This is done in “SYSTEM SET UP” in the “UTILITY” menu. Please refer to “2. SYSTEM SET UP” (page 23)
under “0 UTILITY” for ifurther details.
(2) Handling the clock signal
When carrying out EQ processing by inputting the digital audio signal to the unit, the clock should be set with the
“UTILITY” menu.
If all signal transmission and reception is carried out digitally by taking the unit as a part of the digital audio
system, it is better to operate the unit with a clock signal provided by a unit which is the main controller of your
digital audio system.
For example, when a digital mixer is set in the center of the digital system and the clock signal generated from the
mixer is set to the synchronization master, the word clock signal distributed from the digital mixer should be input
to “WORD CLK IN” terminal on the rear panel of the unit and the clock signal should be used to operate the unit.
[Example] When the digital mixer is the center of the system
Audio signals
n
/;
•Distributor
☆ Even when the unit does not receive the word clock signal, it is possible to operate with a clock signal extracted
from the digital audio signal.
For operation with a signal received from another input system, it can be set in the item “CLOCK” in the
“UTILITY” “SYSTEM SET UP” menu.
If the word clock signal is not synchronized properly, all the “Fs” displays go out. Check to see if the connec
tions are made properly again.
Word clock
All the digital audio equipment operates based on a certain word clock signal.
This signal determines the operation sampling frequency and also the timing when the digital audio signal is
transmitted and received.
For the transmission and reception of the digital audio signal between equipment, this signal should be
synchronized. Otherwise, proper signal transmission and reception is not possible.
Therefore, you must make sure that the word clock signal is synchronized when transmitting or receiving
digital audio signals between different equipment.