System configuration, 3 power supply module – Toshiba Programmable Controller PROSEC T3 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. System Configuration
1.3
Power supply module
The following table shows that two types of power supply modules
are available, depending on the power supply voltage. These
modules can be used for both the basic unit and the expansion unit.
The power supply module is mounted in the extreme left of the rack.
However, the expansion rack that is connected to the standard
expansion IF may not need the power supply module. For details,
see 1.9 Examining the power supply capaci^.
Type
Rated voltage
Frequency
PS361
100-120 Vac/200-240 Vac (selectable)
50/60 Hz
PS332
24 Vdc
POWER LED
Fuse
\
Tenninal block eject screw
(on top at bottom)
Run signal output terminals
Voltage switch terminals
(100 to 120 Vac... ^ort\
1200 to 240 Vac... open
)
Power su|:^ly input terminais
Line filter ground terminal
Frame ground terminal
Module fixing screw
User's manual - Hardware
13